Jobs
Vibratory Tumbling Media
Vibratory Tumbling Media
2.3.1 Consider the material of your parts:
Different types of media are suitable for different materials. For example, ceramic media with brown aluminum oxide abrasive is commonly used for the general deburring of hard metal materials, while plastic media is often used for aluminum and zinc die-casting parts.
2.3.2 Determine the desired finish:
Different types and shapes of media can produce different finishes. For example, ball-shaped media can produce a smoother finish, while pyramid-shaped media can be more aggressive in cutting and producing a matte finish.
different media shapes
2.3.3 Choose the appropriate size of media:
The size of the media should be smaller than the parts to ensure efficient tumbling and prevent parts from getting lodged. If the parts are much smaller than the media, you may need to consider using a reverse separation process.
2.3.4 Consider the shape of the media:
The shape of the media should be chosen based on the shape and complexity of the parts being tumbled. Choose media with shapes that are less likely to lodge in or damage your parts.
2.3.5 Determine the media-to-parts ratio:
The amount of media in the tumbler is critical to achieving a successful tumbling process. Generally, a 3:1 media-to-parts ratio is recommended for most tumbling applications. However, delicate parts may require a higher media-to-parts ratio to prevent parts-on-parts impingement.
2.3.6 Test and adjust:
It's important to test and adjust the tumbling process to ensure the desired finish is achieved. Make adjustments to the type, size, shape, and amount of media until the desired finish is achieved.
2.4 Compound and Water
Choosing the right compound for your vibratory finishing process is a critical step in achieving the desired finishing result. Consider the material being finished, the desired finishing result, and any environmental and safety factors when choosing a compound, and be sure to follow the manufacturer's instructions when diluting the compound.
Hyde Lea is a village and parish in Staffordshire, England, just west of Stafford itself.
Hyde Lea borders the southern boundary of Castle Church parish. It is made up of a detached strip of land between Thorneyfields Lane and Burton Manor. The small village became part of Castle Church parish in 1881.
By the time of the 2011 census Hyde Lea had become a civil parish in its own name. The population as of the 2011 census was 451.[1]
'The Hyde' was mentioned as far back as the Domesday Book. By 1788 Hyde Lea common was ringed by small encroachments and by about 1840 there were a few cottages there, several dating from the late 18th century.
Hyde Lea boasted a school from 1863, but it closed in 1980, children only staying there between the ages of 5 and 7 by this time. The village hall site is now owned by the trustees (the community). In the 1980s the Diocese allowed the community to use the school as a village hall on licence until the trustees purchased it in the early 1990s.[2]
It contains a Scheduled Monument in the form of a moated site and fishpond used for water management at the head of the valley of Rising Brook.[3]
Stafford Grammar School is within the parish.[4]
